Technical Regulation and Remuneration in Furniture

0 1,048

The main task of technical regulation is the development of progressive, technically sound production standards that contribute to the growth of productivity, better use of machines and cost-effective consumption of materials.

As a result of technical regulation, measures are overhead (loss) working hours, insufficient use of equipment, tools, and fixtures and reveal the reasons hampering the growth of productivity and performance mechanisms Development Center – investment projects and websites. Methods of technical normalization, by means of which the study of the production process is conducted, are timekeeping and photographing of the working day assembly of section gates

The essence of timekeeping is to use a stopwatch (stopwatch) to accurately record the time spent on performing any production operation. Working day photography is to monitor the workflow during the shift with an accurate record of the use of total hours, machine time, unproductive losses, etc.

According to the technical standards, the technical standards for the manufacture of products or parts thereof are established. There are technical standards of time and standards of production The norm of time is the amount of working time spent to perform a given job in the conditions of this production

The rate of production is the amount of production that the worker is obliged to produce per unit of time under the conditions of production. The production rate can be expressed in pieces of products or parts or in the number of operations per hour, change. The rules are not permanent. They change depending on changes in production conditions, the introduction of new equipment, improvement of working hours

Payment is made depending on the degree of complexity of the work performed and the skill of the worker. The level of qualification is characterized by discharge. Seven digits are installed for carpenters. The tariff-qualification directory gives a list of works that the joiner of each category must be able to perform with the proper quality of production and compliance with established production standards. Workers are assigned the grades by the administration of the enterprise upon submission of a qualification commission, which tests the knowledge, skills, and skills of workers

Wages are calculated on the basis of set tariff rates in accordance with the category. Each category is assigned a tariff coefficient indicating how many times the wage rate of the carpenter of that category is higher than the rate of the carpenter of the first category, taken per unit.

Leave A Reply

Your email address will not be published.